RepRapBuilding.INFO

slic3r instelling
PRINT SETTINGS
Layer high 0.3 mm
firstlayer heigh ratio 1
infill every N layer 1
extrusion with ratio 0

skirt
loops 1
distance from object 6
skirthigh 1

retraction

length 1
lift Z 0
Speed 30
extra length on restart 0
minimum travel 2

print settings

perimeters 3
solidlayer 3
fill density 0.4
fil angel 45
fill pattern rectilinear
solid fill pattern rectilinear

tool support primary

PRINTER and FILAMENT

nozzle diameter 0.5
z offset 0

Filament

diameter 3.0
extrusion multipler 1
Temperature 190 pla 210 ABS
First layer temp 190 pla 210 abs
bedtemp 60 pla 120 abs
first layer bed temp 0

SPEED

travel feed rate 190
perimeter feed rate 50
small perimeter feed rate 55
infull feed rate 60
solid infull feed rate 60
bridge feed rate 60
bridge flow ratio 1
bottom layer ratio 0.35


COOLING

nothing

Slic3r V0.7.1

acceleration = 0
bed_temperature = 0
bottom_layer_speed_ratio = 0.3
bridge_fan_speed = 100
bridge_flow_ratio = 1
bridge_speed = 60
cooling = 0
disable_fan_first_layers = 1
duplicate_distance = 6
duplicate_x = 1
duplicate_y = 1
end_gcode = M104 S0 ; turn off temperature\nG28 X0 ; home X axis\nM84 ; disable motors
extrusion_axis = E
extrusion_multiplier = 1
extrusion_width_ratio = 0
fan_always_on = 0
fan_below_layer_time = 60
filament_diameter = 1.75fill_angle = 45
fill_density = 0.4
fill_pattern = line
first_layer_bed_temperature = 0
first_layer_height_ratio = 1
first_layer_temperature = 200
g0 = 0
gcode_arcs = 0
gcode_comments = 0
gcode_flavor = reprap
infill_acceleration = 50
infill_every_layers = 1
infill_speed = 120
layer_height = 0.2max_fan_speed = 100
min_fan_speed = 35
min_print_speed = 10
notes =
nozzle_diameter = 0.35
output_filename_format = [input_filename_base].gcode
perimeter_acceleration = 25
perimeter_speed = 60
perimeters = 3
post_process =
print_center = 100,100
retract_before_travel = 2
retract_length = 1
retract_lift = 0
retract_restart_extra = 0
retract_speed = 30
rotate = 0
scale = 1
skirt_distance = 6
skirt_height = 1
skirts = 3slowdown_below_layer_time = 15
small_perimeter_speed = 30
solid_fill_pattern = rectilinear
solid_infill_speed = 120
solid_layers = 3
start_gcode = G28 ; home all axes
support_material = 0
support_material_tool = 0
temperature = 200
travel_speed = 130
use_relative_e_distances = 0
z_offset = 0

Thomas

_________________
www.3daybreaker.blogspot.com